Quote:
|
Which soundcard was used by the author of the REW?
|
The author (John M) has tested most soundcards, so you simply need to get your card set up correctly and you'll be fine.
If you're at the Set Input Volume step, then you must have successfully completed the Soundcard calibration step. Is that correct?
Make sure the card is correctly selected in the pull-downs as I've shown in the picture below for your specific card.
Soundcard.jpg
My notes show thatwith Audigy 2 cards selecting the Line-In is done by selecting "Analog Mix" in the Record panel of the Basic tab of the Creative Surround Mixer then going to the Source panel and muting all the sources
except for Line- In. Also in the Advanced Controls (usually accessed by clicking the + symbol for the input) you need to have Record Without Monitoring selected. Be sure to not select "What U Hear".
Hopefully you're using the left/right line-out jack on the soundcard with a stereo adapter, and then only using the right channels of it and the line-in's stereo adapter.
Quote:
|
Should I have all three subs on at the same time?
|
Setting up multiple subs is a bit of a challenge for sure. Most people do one at a time and them again with them all on to clean it up. Tough job.
brucek