[blakjava]

I have not gotten to the Calibrate Soundcard step yet. The guide says "Once the measurement level has been set, the input volume has been set, and the SPL reading has been calibrated, the Wizard is ready to make a calibration measurement of the soundcard's frequency response." I have two line-in choices on the wizard menu for my soundcard. Then there is a troubleshooting note that says on the Audigy2 selecting Line In is done by selecting "Analog Mix" in the Record panel. Does that mean I don't select either Line In choice? That's why I figured if I use the same card used to create the Wizard instructions I won't run into these discrepancies.