Quote:
|
Once you have calibrated for your House Curve, how do you match the sub to the fronts so the house curve is consistent into the highs?
|
Most of us around here use Room EQ Wizard software, and after we have equalized the sub alone, then add the mains and adjust the subwoofer amplifier to match levels at the crossover. If you have a BFD you can't really adjust the processor subwoofer trim at that point because it will upset the level feeding the BFD which was previously setup.
Without REW, you will simply adjust your subwoofer amp after equalization by ear. Whatever sounds good to you. There is no right or wrong level - just guidelines to match them so they blend together at the same level at the crossover.
Quote:
|
but what about the high end? Same process?
|
This would imply an equalizer being used on the mains? Not generally done since it adds noise and little is gained. Usually higher frequencies respond to room treatment..
brucek