Quote:
MikeSp wrote:
 I am using a Velodyne SMS-1 parametric equalizer to equalize three subs and it does a great job. BUT -- two of the subs have "auto-on" circuitry to turn them on and during the calibration procedure, the SMS-1 will NOT cause the two subs with auto-on to turn on. I must put in a DVD and switch the pre/pro to THX 5.1 in order for them to switch on (can then turn the DVD player off) and THEN do the calibration if it doesn't take longer than 10 minutes. HOWEVER, if I am moving the subs around and fiddling with the phase controls, it takes time and after ten minutes or so, the two subs with auto-on turn off.
QUESTION: is this behavior typical of the SMS-1 and subs with auto-on OR does the SMS-1 usually cause various subs to turn on by themselves?
Thoughts, opinions??
MikeSp |
Later on yesterday I tried again and everything worked great as it has today--dunno what happened for those wasted hours -- appeared to be some sort of hiccup that went away (hope it stays away). ALSO, I found that Curt from Velodyne provided GREAT support.
MikeSp