[sammythebu11]

Hi,
I am trying to Equalize my IB sub and I am doing everything (I think) according to the guide but when I get to the point of "Assign Filters" the software only generates filters above 100hz.
I am using a mac and I can:
Set the measurement level successfully, I can calibrate successfully, I set the target level to 73.7.
When I "Find Peaks" sometimes I get a message saying that the peak is at 30 some DB and it is too low, sometimes I get through without any problems. if it is successfull and I click on Apply Filters, then the software applies between 6-7 filters ALL of them over 100hz and under 200hz.
Can someone please tell me what I am doing wrong?

Thanks,

The Bu11