Quote:
Otto wrote:
 Hi, Martin,
It appears that, at this point, you are simply measuring your response before doing any processing. I don't think it matters what your target is for that step, but brucek is right that you will want to get that straightened out when you do the real measurement. Maybe I'm missing something else...
Did you get all the calibration stuff right? The cal of the SPL meter, etc.?
Can you increase output on your sub at all? It seems like your sub is quite a bit lower in output than your mains. Many of us shoot for the opposite of that.
Good luck. |
Hi Otto,
What do you mean? (in red). Sorry, but I donīt understand.
Iīm not sure that I got the cal of the SPL meter correct. But, a cal pop-up window comes when I start REW. (The response of the SB24 was relatively flat when I did the measure, before I did the cal.) After the cal a black line came
Yes, I can increase the output if I want to, but I tried to get the "spikes" in the same level as the sat's. If I turn up the sub it sounds boomy. After I have cutted down the spikes I can increase sub.
//Martin