| Re: Creating my first house curve
OK, I was thinking that you get your normal target done, then apply a house curve, and then it somehow transformed the existing filters.
So do I have this correct in that basically what I need to do is to start over, except this time I alter the target using the house curve before I start applying filters. Then I have it apply the filters, optimize them, and tell it to adjust the gains to the target. Before I get started turn the sub up so that it measures 80dB at say 25 hz, and run the Measurements and adjustments from there.
Do I have this right?
The other question is what level do you then use when you calibrate your sub to fit with your mains? I assume you aim to have say 50hz to be at 75dB while letting the lower end run hot?
|