Quote:
brucek wrote:
 Do nothing different, except hook up or turn on the mains.
You will need to reset the levels because the mains will change the loudness. But basically you do the same measurement with the sub as you did before.
Then you look at the area around the crossover and adjust the phase of the sub if there is a problem and try and get a smooth transition between the mains and sub.
BTW, did you do the Calibrate SPL routine and after that press the Set Target Level button?
brucek |
I hooked up the mains prior but only had sound coming from the right due to the rca right only being hooked up on the avr. i guess i should make the full rca connection at both halves and retry?
thanks for the tip about the phase, ill check it out, i know i can move it around too and ordered a 25' cable to do so.
i did do the calibration routine but not sure if it was before or after i loaded the cal file, i will double check thank you