Quote:
|
I don't see any REW filter assignments/suggestions under this measurement.
|
I think you would benefit a lot by reading the
REW HELP files. They explain all this section quite well.
I don't think you pressed the SET TARGET LEVEL button as shown the upper arrow in the attached jpg. You have a target level over 95dB. Before you do the Measurement and after you've executed the CALIBRATE SPL routine in REW you need to SET TARGET LEVEL.
You also won't have any peaks recommended if you're that far above the target line.
Once the correct target level is set, to get peaks and filters you need to press FIND PEAKS, ASSIGN FILTERS, OPTIMIZE PK GAINS as shown by the bottom three arrows in the attachment.
set.jpg
It's a fairly good response though. You won't have much to do once you get the target levels set.
brucek