Looks like you haven't use the Set Target Level button before measuring?
Quote:
|
It seems like the measurements between speakers are at significantly different levels, and I assume this is not the proper procedure.
|
No, it's correct. You have to go through the calibration to 75dB for each speaker you measure - only takes a second though
Quote:
|
I am still getting sound above 80hz. I am considering changing and setting the crossovers on the subs
|
An 80Hz crossover isn't a brick wall. It's a slope - usually 4th order, so the signal drops at a rate of 24dB per octave. That's normal.
The mains crossover usually is a 2nd order with a drop at 12dB per octave. REW has a selection for the crossover type. Look under the hidden Target Settings panel at the left panel of REW. (The Set Target Level button is there too - it just doesn't look like a button).
Quote:
|
I have some graphs to show you that might help to figure out what I am doing wrong:
|
You are measuring too high and haven't set your target properly.
brucek