[mightyoakbob]

Hi everyone, still trying, several days now, still getting nowhere.

I'm really puzzled by the "setting the target level". I have a graph for my sub in my room and wish to try to correct it. The manual says the target is usually set too high and tell me to get it right. It does not say how I recognize right and it is not obvious to me at all. What does right look like?

Someone on another forum looked at my graph and said he thought the sub was running 8db too low to compensate for massive room peaks. I took that to mean I should lower the taget by 8db to push more of my graph above the line where it could be cut by the BFQ. I tried to move it down expecting the graph to move which it did.

Then I got a message about connections and dates and processors I didn't have - no sense at all.

I pressed on and then got a message that my levels were too low. I then realized that it was not just on paper, it was trying to use my system, so I switched the amp back on and tried again. It then told me my target was 75.6db which is 0.6 higher than I started - what is going on?

What does a correct target level level look like. the notes just don't say?

Cheers,

Bob.