| REW/BFD input level setup on a yamaha rx-v661 ?
Not sure if this is in the correct forum...Here is the scenario...
A Yamaha r-v661 with amps used for the front and rear pre-outs and a sub connected....I'm trying to set up my BFD input level by turning on the receiver and setting it at 0db(calibrated to 75db reference volume) and then turning off all amps (and sub) so I can watch the input level bars without destroying my ears. I'm using the Flight of the phoenix clip to find an input level.
Every time I get a few seconds into the clip the receiver shuts off. If the volume is reduced a few dbs it does not do it? What is happening? The internal amps aren't being used at all?!?!? Is this a faulty receiver? Am I doing something wrong? Is the source signal clipping which is turning off the receiver?
Last edited by tdamocles; 10-23-07 at 07:33 PM.
|