[yswong]

Here's my new graphs going through my AV. I measured them with my sub in a 2 different positions.

Graph 1 - Position 1
graph 2 - position 2
graph 3 - filtered graph 1
graph 4 - filtered graph 2

I'm still deciding which graph to position. Those filtered graphs are what REW suggested. I didn't modified anything. Graph 1 few dips. Graph 2 is OK but the response between 30 to 40 Hz are too low.(I with they are higher) I wonder if I can bring them to target response . If yes, how do i go about doing it? I'm still learning how to play with the filters. Brucek, you were saying using the filters above 100Hz is a waste, so should i just turned those filters off in EQ filter?