| Re: Getting started with IB project...
Quote: | Sonnie wrote:
Actually Darren and I were discussing the SS RL-p15 earlier. He stated ThomasW had recommended the dual 4ohm version due to its higher Qts of 0.447... which is indeed higher than everything else I've been looking at. Of course I have no idea how that figure comes into play. I don't understand all the TS parameters and their various explanations/uses, etc.
As far as xmax... I'm going by what I've been reading about some of the lower xmax drivers being pushed to their limits fairly easily. I may not need the full amount offered by these drivers but I've not seen anything around the minimum of probably 18-20mm that I would at least like to have. I'm still looking though. $2000 for 8 drivers is pretty stout. | Ah, so as far as Xmax utilization is concerned (and just about everything else) you should be fine!. Wasn't sure if this was the 2ohm version or 4ohm version of the driver you planned to use. And yes, I can see why some fairly high xmax drivers are easily being pushed to their limits, IB is very efficient. You lucky dog you...how did you convince the wife to okay this one?? hehe
If you don't have a BFD for your sub, get one fast!
If you don't have REW, get it now! |