Quote:
|
I wanted to start by using my avr's audyssey program as a start and use rew to see what it's doing...................Then I was going to fine tune with the bfd
|
Yep, many people with auto eq do this...
Quote:
|
So I put the bfd back in and pressed the in/out button(flashing) and assumed I was in bypass mode, straight in-out. I then took another measurement to see if my graphs changed and they did, a lot. But no filters are being applied. Why would this be?
|
Green LED on=filters engaged.
Green LED off=filters disengaged.
Green LED flashing=Filters disengaged, with VU meters displaying input level rather than output level.
With the in/out LED flashing or off, the BFD offers unity gain. There would be no modification to the signal or its level....
Quote:
|
Another odd thing is when I do a measurement and get a graph and then generate a waterfall of it the peaks on each are different? They look similar but the peaks line up at different freq.
|
Move the slider to a single slice of 1. It will be the same as the frequency response graph. The peaks will line up exactly the same..
brucek