| Rookie Q's on REW
Finally started to use REW, and went through the help and Soundblaster Live threads and think I have set everything up right.
I'm using an SMS-1 with the most recent firmware fixing the subsonic filter and distortion issue. Have set the subsonic filter to 1hz and the slope to 6db/octave on the SMS-1 (I have a PB13).
When I hit "find peaks" to have the REW help with the SMS1 settings, I get an "Find Peaks Warning" that says "The Target Level may be set incorrectly (too low) or teh speaker type or Cutoff may be incorrect, giving a Target response that is much lower than the measured response within the peak search range". The Target level is 78.9, the largest peak found was 33.7db. Speaker type is subwoofer and crossover set to 24db/octave, cutoff is 80.
Something is obviously incorrect, as when I try to assign filters all the filter adjustments are north of 120hz, execpt for one at 35hz and one at 38, and all indicate to cut 12db.
My measured graph (uneq'd) is below ... help!
PBC
|