| Re: Rookie Q's on REW
You still have your mains on, so observe how much signal is above the target after the 80Hz crossover. Turn off your mains and redo the measurement. Always measure the sub only to start the equalization and measurement process.
In addition to that (once you have your mains off) I would set the Find Peaks maximum to about 100Hz. There is little reason to filter above that frequency since the mains will overwhelm the situation when turned on above the cross.
Filters 7 and 8 at 35Hz and 38Hz look correct to remove the one real peak you have to deal with. As far as the peak at 18Hz is concerned, the default minimum Find peaks frequency is usually 20hz (since that's as low as a BFD will filter). I do believe you can set the minimum lower to 15Hz for an SMS though..
brucek
|