Quote:
Otto wrote:
 Hi Matt,
You can overlay the plots on the same set of axes so they're easier to compare. In the filter window, there are tabs, and one is called "All Measured." Select that one and then you will be allowed to choose which of your (up to) nine measurements you want to overlay.
I would probably push the output of the sub a little bit, such that you go above the target by 5 6dB or so. Then, you will be able to quash peaks more, such that you get a flatter response. This assumes you have the headroom, which you will with the EP2500 amp. Just turn the amp gain up a little and remeasure and refilter.
I also like to apply some gain in the dips. Not too much, and I like to play with it manually, either on the front panel of the BFD or through REW and the MIDI download (either way is OK, but the point is it's me picking the filter values, and not REW). |
Okay Otto, Since I set up my system with my amp gain at max, I assume I can adjust my SW output on my receiver to boost the output. I will also overlay and repost. I'll play around with some gains but from my understanding I should keep these on the lower side to prevent clipping???
thanks again for your suggestions. BTW...should my Target be the same for both measurements? seems logical but I have to manually adjust when I re-measure with filters. Make sense?