Ok got it... I hate plugging directly from ins to outs. But THANKS! ...it worked. Next problem is still the same though. When I do a measurement it tells me that the input is too low so a ctrank up the amp and the sound is piercing but it says too low, reading is about -50 to -40. I still get readings but not sure if they mean anything because of this. I will upload my soundcard graph and new plot. For some reason I get an "error on page" when I try to add an atatchment using this computer. I turned off pop-up blocker, but that did not help. And, Yes after this it is on to the mic!
jam
Quote:
Wayne A. Pflughaupt wrote:
 That’s the correct connection scheme, but for measuring, not for calibrating the soundcard. If you’re trying to calibrate the soundcard, you’ll need to loop a cable between the main output and the channel strip you intend to use, as indicated in Item #1 in the REW help files for Calibrating the Soundcard. There should not be a mic connected, or a connection to the sound system, until later when you’re ready to measure. Regards, Wayne |