Quote:
falcon935 wrote:
 -UPDATE-
Parts came today. Installed fuses and re-installed board to check for further shorts. The TV came on. Removed board and installed new convergence chip.....
IT LIVES!!! 
Thanks for all you help.  |
Hi everyone. I too have found the same two fuses blown and have ordered the STK393-110 and pico fuses. Do you have any instructions on how to remove the board from the chassis? I have pulled the whole projection system out the back, thinking I would do the work with the board installed, but if it's easy to remove, it'd be easier to get at that heat sink the STK is stuck to.
My biggest worry is the board-to-board connectors. Looks like one end is soldered into one side, then a 'V' strain relief, then the other end of the ribbon cable is a connector of some sort. Does that connector lift straight up? Or does it pull toward the other board? I don't want to screw up the connector - as that would then take me much longer to repair...
Thanks for any advice...
Regards,
jt