Quote:
|
So the only way to test the response of each individual speaker is either to use the 5.1/7.1 anlog inputs, or route the signal through all speakers and physically disconnect the ones not being tested?
|
I guess there might be an occasion where you want to observe the crossover region of the center and rear speakers. In that case the 5.1 bypass input wouldn't do much for you. I don't know of any processors that would steer to a specific speaker without the other speakers playing too, so you would indeed have to physically disconnect them.
If you were attempting to test each speaker on its own with crossover and in its native position, then you would just have to connect each one individually as a left or right main and run the sweep.
Is this something you're trying to attempt?
brucek