Quote:
Yeah OK, I get what you were referring to.
First you calibrate the soundcard as you did, but after that you need to run the Check Levels routine in the Settings popup. It will create a subwoofer signal, and you need to turn up your receiver until your own SPL meter reads 75dB at the listening position. Then you set the Input Level to finish the Check Levels routine.
Once you've done that, you have to tell REW that its own SPL meter is reading 75dB. How would it know otherwise. To do this you press the CALIBRATE SPL in the Settings popup under the Meter tab.
Then you can Measure.
brucek
|
I see Brucek, Thanks for the explanation. I've done a soundcard cal. measurement, but i'm not sure if I didi it right, the curve is perfectly flat till grad rolloff below (75.4db at 10 down to 67db at 2hz), and only a sl. drop off (75.9 at 10khz to 75db at 20dhz) Does this sound right?
(I too havent' yet figured out how to post graph
I'll save this as a soudcard cal. file and proceed as you mentioned if this is right.
Thanks, this is way more complicated than anticipated hehe
Fore
Oh, one more thing? When I hook it up the AVR and DEQ to Check Levels, or whenever I get to the stage of having to choose Equilizers, there's no DEQ option, should I choose BFD Pro DSP1124 or BFD Pro FBQ 2496 or just Generic?