Quote:
Funkmonkey wrote:
 -be mindful of which side of the cutting bit you measure from
(for an ID inside dimension, or OD outside dimension you need to measure from opposite sides of the cutter) |
..... ya i did that and had to re-cut my mounting piece for my sub. BTW thats how i made my jig, worked well and wasnt too hard. i also found that cutting one sided, then flipping it over to cut all the way through was not the best way. i found that if i did it that way i would leave a lip or the cuts would be kinda off centered, its hard to explain. so what i did on my last pieces was just cut as deep as it would, then move the bit lower until it cut all the way though. hope that helps!!! Good advice Mr Funkmoney