Quote:
|
Yes I did calibrate SPL, it was fairly high though 96
|
You are supposed to set it to 75db.....
Quote:
|
What should I target the handheld SPL Meter for (i.e. Stereo system volume) during REW SPL calibration?
|
Hopefully, you've read the
REW HELP FILES......
With the mic connected to the line-in, and the line-out going to the receivers AUX in, and the receiver in stereo mode, with the mains disconnected so the sub only is playing, then when you run the Check Levels routine, set the SPL level in the room to 75dB at the listening position with the receivers volume control (after you have the REW output level set properly as seen below.
Then when you get to the part in the Check levels routine where you set the input level, set it to -12dB as shown in the pic below.
Then run the Calibrate SPL and set to 75dB..
Measure.
THis shows the interaction of the Windows mixer and the controls in REW
Windows MIXER plus REW Mixer control interaction.jpg
This shows the REW controls and the input output effects.
Check Levels soundcard_cal.jpg
brucek