Home Theater Systems - Electronics and Forum - HomeTheaterShack - View Single Post - Build your own a/v component cabinet
View Single Post
Old 03-03-08, 12:47 AM   #5 (Link)
bricot
Shackster
Alias: Brian
Loc: Oregon
User: #15221
Since: Jan 2008
Posts: 15
  bricot is offline  
Re: Build your own a/v component cabinet


Here's what I have found so far. I think I will go with these fluid drive fans, there 120mm and only run at 8dba at 800 rpm, virtually silent. http://www.coolerguys.com/sff21.html

I'm thinking about running 4 of these, perhaps with a Silent X 4 channel fan controller.
http://www.newegg.com/product/produc...82E16811999167

Still trying to figure out if I want to control the cooling system with a thermostat.

Being a fireman I've always been a 'fan' of positive pressure ventilation, I can ventilate an entire house with one gas fan blowing in a door way and 1 window open at the farthest point of the house, seems like the fans set in intake mode would work the best. The key is have your exhaust hole 1/4 to 1/2 the size of intake hole(s).

I'd like to get a intake filter, something like this, http://www.triktags.com/html/fan_vent_panels.html, except sized for the 120mm fans.


Forum Rules Reply With Quote