Hey
Wasn't quite sure where to make this thread.. if this isn't the right place I hope a mod will just move it.
I just got a Behringer DCX 2496 - and I want to connect two subwoofers to it.
I have OUTPUT 1 (Left subwoofer) & OUTPUT 2 (Right subwoofer). They are connected to the EP2500 which is powering them. Then I have a cable from "INPUT A" to my surround receiver "SUB PRE-OUT".
All I want to do, is to just set it up correct - so that I can play music and watch movies etc. And I need to know how I set the subsonic filter to 15hz on OUTPUT1 and 23hz on OUTPUT2. I have also boosted the signal with +3dB on both OUTPUTS and the INPUT (so that I don't have to turn the gain so much up on the EP2500).
I must have done something obviously wrong, because when I turn the gain just a tad up on the EP2500, the subwoofers are just humming.
PS: I do have the manual... and I might figure it out sooner or later.. It's just that I want to set this thing up RIGHT NOW..
Also: Is there a way to delete all the old settings on the DCX ?