[Wayne A. Pflughaupt]

Welcome to the Forum, xboy!

Last time I tried, when I did the next measurement and I open the EQ settings, it doesn't know anything about the filters that are already in use to give these new results.

That is correct.

But what should I do to properly get a "remeasurement" so that I can iterate over my set of filters and have a properly updated graph?

Your second sweep is an "updated graph, " as it reflects the filters you added. You can compare your second measurement to the predicted response of the first by calling it back to the screen (up to nine measurements are kept in que on the left side of the screen). If comparing the second measurement to the first shows that you didn't get the desired results after the filters were added, you can tweak them further in the first window, make the changes to the BFD, and take another measurement.

Alternately, you can use the RTA feature and tweak filters in real time.

Regards,
Wayne