Quote:
fibreKid wrote:
 Hello;
I have an older Denon 3805 which has the older eq stuff not the new Audyssey.
What mains do you have, can you tell the avr that there is no Sub and set the speakers to large?
What happens if you run a sweep that way and then add the sub back to the equation? Does this mess the avr up?
-john |
You know, I have always been in the mind that Audyssey wouldn't work right or equilize correctly if the sub was not in the mix to begin with, but maybe that is not the case
. I too have a 3805 and have yet to look at what it does with the sub - if anything. For mains I have Klipsh RF-3 (specs say they go down to 37Hz) which means the AVR should EQ below my crossove point and then I would be EQing the sub with the BFD. Maybe you are on to something.
Have you tried the method of adding the sub after the "setup"?
Bill