[Wayne A. Pflughaupt]

augmont wrote:

The crossover is 80hz and speaker set to small. Is the reciever not doing it's job?

Well, you noted in post #6 that it was a “sub only” graph. I assume that means you did not have the receiver in the signal chain at the time. The receiver can’t “do its job” unless it’s in the signal chain... Using the CD or AUX input will put the receiver in the signal chain.

On the end Freq, i set it at 200hz? should that be changed?

If you’re referring to the graph axis, 200 Hz is fine.

Should I unplug my mains (i thought i did but really can't remember)?

Typically recommend graphing the sub first, then adding the mains, but that’s if you’re equalizing the sub. Since you’re not doing that yet, it doesn’t matter.

Regards,
Wayne