[Rambo4]

Hey, just setup my REW, following the instructions, and have results that look like an actual response curve. Just can't really say I am happier from getting the software setup properly or sadder from seeing my actual response curve. haha

Here are the curves. These are all taken in a 14 x 18 x 8 room with two AS-F2 speakers and a Velodyne DLS 5000R in front corner powered by an HK 635 receiver.

(Edited out the first graphs posted as they included the mains in them, which is not my primary concern. Still learning...)

1) HK Flat response (darker purple) mains at full range + sub VS Ezset/Eq mains 60Hz + sub (pink)

2) Full range right main response curve (blue) with no sub - tone flat no ezset/eq

3) Full range left main response curve (red) with no sub - tone flat no ezset/eq

4) Subwoofer only mains disconnected (aqua) - tone flat


Any ideas of where to go from here whether a BFD is useful with so many nulls, position my subwoofer somewhere else, any help I'll welcome!

Thanks!