FBQ 2496 Range??

[joz]

Just a simple question..

At what FR can the FBQ operate??

I have one already running my SW's which will probably run between 2
0-80hz.
But can I add a second one to do the range from about 80-600hz??

I know a deq could do it,but I suppose I'm just trying to keep the mids out of ant extra AD/DA coversion.

[brucek]

At what FR can the FBQ operate??

20Hz-20KHz..

brucek

[avaserfi]

I am not sure if the FBQ is the same, but the DCXs range can be extended by using a low Q filter at the low/high end of its range. Such use extends the function of such units, but is not as accurate. If used in such a way proper loop back measurement would be recommended before real world implementation.

[Wayne A. Pflughaupt]

joz wrote:

But can I add a second one to do the range from about 80-600hz??

Sure, as long as you're using an outboard amp for the mids. The only way to connect an equalizer is between the pre-amp and amp.

I know a deq could do it,but I suppose I'm just trying to keep the mids out of ant extra AD/DA coversion.

You'd be surprised how sonically pure the conversion is on digital gear these days, even cheap stuff like Behringer. It won't be a problem as long as you're using a good equalizer. If you notice any audible artifacts, then upgrade the equalizer.

Regards,
Wayne

[joz]

Thanks Wayne,yes my system is active with amps for each driver.
Ok great so I can plug another FBQ into the bass driver output from my RaneAC23..

Regards,
Wayne

Cheers thanks,atm the the FBQ is doing the eq/peq and no probs so far.



Also so I don't start another thread..

Is it possible to get an extension lead for midi connection??

The one on the edirol is very short.

[joz]

brucek wrote:

20Hz-20KHz..

brucek

Excellent thanks,just makes me wonder why people use it just for bass??

[spearmint]

joz wrote:

Cheers thanks,atm the the FBQ is doing the eq/peq and no probs so far.



Also so I don't start another thread..

Is it possible to get an extension lead for midi connection??

The one on the edirol is very short.

I use a pair of 5Mtr (in/out) leads with my USB/Midi adapter with no know issues.

[Wayne A. Pflughaupt]

Thanks Wayne,yes my system is active with amps for each driver.
Ok great so I can plug another FBQ into the bass driver output from my RaneAC23.

Or an analog EQ, if you prefer...

Regards,
Wayne

[Wayne A. Pflughaupt]

Excellent thanks,just makes me wonder why people use it just for bass??

Because most people don't have separate amplification. Upgrading from a basic receiver, which is what most people have, to all the additional hardware needed to accommodate full-range equalization is a big-buck proposition, even if you buy used gear. Not to mention the required real estate in the equipment rack...

For most people with a late-model receiver, the on-board equalization is adequate or their needs, especially with the more upscale receivers.

Regards,
Wayne

[joz]

spearmint wrote:

I use a pair of 5Mtr (in/out) leads with my USB/Midi adapter with no know issues.

Jaycar??

Wayne A. Pflughaupt wrote:

Because most people don't have separate amplification. Upgrading from a basic receiver, which is what most people have, to all the additional hardware needed to accommodate full-range equalization is a big-buck proposition, even if you buy used gear. Not to mention the required real estate in the equipment rack...

For most people with a late-model receiver, the on-board equalization is adequate or their needs, especially with the more upscale receivers.

Regards,
Wayne

ofcourse thanks.