 |
| Home | About Us | Rules | Register | Gallery | Glossary | FAQ | ||
               | ||||||||
| |||||||||||||||||
| |||||||
| BFD | Electronic Equalization Devices DSP2411p - XLR or 1/4" to RCA? Discuss DSP2411p - XLR or 1/4" to RCA? in the Equalization | Calibration forum; DSP2411p - XLR or 1/4" to RCA? Hi Folks, Got a DSP2411p and an ECM8000 (plus behringer mic pre=amp) on its way. I will be connecting the ... |
  |
|
Views: 506 - Replies: 1
| Thread Tools |
 03-31-09, 10:21 PM
| #1 | ||||
| DSP2411p - XLR or 1/4" to RCA? Hi Folks, Got a DSP2411p and an ECM8000 (plus behringer mic pre=amp) on its way. I will be connecting the DSP2411p between a Velodyne Sub and a Rotel RSP1069 processor (RCA inputs/outputs). What would be the better connection type, XLR-RCA or 1/4" to RCA? Or does it even make a difference? Thanks, JR | ||||
  |
 Advertisement | |
  | |
| 04-01-09, 12:36 AM
| #2 | ||||
| Re: DSP2411p - XLR or 1/4" to RCA? It shouldn't make any difference because in either case the balanced output is not used and only an unbalanced signal is run through the cable to the RCA end | ||||
| |
