 |
 | |||||
 |  |  |  | ||
 |  |  |  | ||
 |  |  |  | ||
| ||||||||||||||||||||||
|  |  | |||||||
| BFD | Electronic Equalization Devices 1124 Power Surge FailureDiscuss 1124 Power Surge Failure in the Equalization | Calibration forum; 1124 Power Surge Failure My BFD has been serving us well for the past couple of years. We had a power surge last week ...  |
  |
|
Views: 255 - Replies: 2
| Thread Tools |
 06-27-09, 10:09 AM
| #1 | ||||
| 1124 Power Surge Failure My BFD has been serving us well for the past couple of years. We had a power surge last week and now all VU levels are pegged at the top. Still works just not at the programmed values. Some of the forum members have recovered from similar situations by powering down and back up. Unfortunately this doesn't help my situation. Have any of you experienced this and will reprogramming the device recover it's functionality? I'll need to completely retrain on this task since my initial experience was long ago and totally forgotten. Not looking forward to going thought this again if it yields nothing. | ||||
  |
 Advertisement | |
| |   |
| 06-27-09, 01:33 PM
| #2 | ||||
| Re: 1124 Power Surge Failure Every power failure or bump certainly causes my BFD(s) to freeze up with the VU meters pegged red. A power cycle on-off always cures the problem. You may have a failure. brucek | ||||
| |
| 06-28-09, 10:32 AM
| #3 | ||||
| Re: 1124 Power Surge Failure Same thing happened here a few days ago following a few power blinks during a thunderstorm. I powered the BFD off, then on and the meters reset to normal. The filter settings were not erased, so all is well. No trees were killed in the sending of this message, but a large number of electrons were terribly inconvenienced. | ||||
| |
