No output to sub with 1124

[edge900rr]

I am hooking up my 1124 for the first time. I have set the input level but I am getting no output to the sub. the sub is just dead, with the BFD out of bypass mode it looks like it is sending a signal to the sub(output levels are moving) but there is no sound coming from the sub. any thoughts?

[brucek]

with the BFD out of bypass mode it looks like it is sending a signal to the sub(output levels are moving) but there is no sound coming from the sub. any thoughts?

Is it sending a signal when in bypass?

Are the connections balanced or unbalanced?

brucek

[edge900rr]

no there is no signal when it is in bypass (the in/out light flashing). I am using 1/4 mic jacks.

[brucek]

I am using 1/4 mic jacks.

Can you be more specific. Are you feeding unbalanced to the BFD input with an RCA to 1/4" TS cable, and the same on the output of the BFD?

brucek

[edge900rr]

yes. I just put it on "of" mode and the sub started working. I was under the impression that it needed to be in "pa" for the eq to be on.

[brucek]

OF turns of a specific filter and PA turns on the filter in parametric mode.

All filters should initially be placed in the OF mode for the program you want to use (i.e. Program 4) . This ensures that none are in the feedback destroy mode.

brucek

[edge900rr]

so after I load the filters then I put it back in PA mode?

[brucek]

so after I load the filters then I put it back in PA mode?

Yes, for every filter you use. Leave the rest in OF.

brucek

[edge900rr]

sweet. thanks for the help