FBQ2496 and leds..

**hasse_swe** · **02-27-08, 06:53 PM**

hello!
doesn't the 2496 have the ability to show output levels on the leds?
only "clip" led that shows when output is too high?....no "warnings before"?..no, how much headrom you may have left?

/H

**brucek** · **02-27-08, 07:16 PM**

No, it seems to me that the FBQ VU meter only monitors input level......

**hasse_swe** · **02-27-08, 07:21 PM**

Quote:

brucek wrote:

No, it seems to me that the FBQ VU meter only monitors input level......

ok...to bad.. =/

and yes..while i'm in search for answers

.. is the "apply 1ft to sub-distance" also for the 2496?
or is it only for the Dsp1124?
thanks/H

**brucek** · **02-27-08, 07:49 PM**

The delay compensation would be the same for the 2496 as the 1124....

**OvalNut** · **02-27-08, 08:05 PM**

Without an output VU meter/clip light, is it fair to say that if you only use cut filters that the output wouldn't be clipped as long as the input doesn't show as clipping? Or not that simple?

Is the above true for both the FBQ2496 and the DSP1124P ?

Tim

**hasse_swe** · **02-27-08, 08:14 PM**

Quote:

brucek wrote:

The delay compensation would be the same for the 2496 as the 1124....

aaah..ok thanks! thought that only where for the dsp models..

Quote:

OvalNut wrote:

Without an output VU meter/clip light, is it fair to say that if you only use cut filters that the output wouldn't be clipped as long as the input doesn't show as clipping? Or not that simple?
Tim

most truly..... was thinking if someone..... i know...we can call him john doe

(not ME of course)

.... whould want to boost some freq..then it whould be handy to see the headroom..

thanks all pro's/H

**brucek** · **02-27-08, 08:49 PM**

Quote:

Without an output VU meter/clip light, is it fair to say that if you only use cut filters that the output wouldn't be clipped as long as the input doesn't show as clipping?

It's just that simple - yep.

Quote:

then it whould be handy to see the headroom

If your input level is set such that there is no headroom at the input, then any gain will clip the output. You must always lower the input level to below maximum with a BFD when you add any gain.

brucek

**OvalNut** · **02-27-08, 09:44 PM**

Thank you bruce. I always appreciate your direct to the point answers.

Tim

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Should I have bought the FBQ2496	n737nc	BFD Forum	4	01-05-08 10:58 AM
1124 Filter LEDS blinking issue	duxfan	BFD Forum	5	10-18-07 07:40 AM
FBQ2496 or BFD1124P	loupy31	BFD Forum	7	06-26-06 09:17 PM
Method to dim DSP1124P LEDs	catnip	BFD Forum	2	06-07-06 01:27 AM
FBQ2496	bobgenie	BFD Forum	5	06-02-06 04:05 PM

Advertisement