I hate to post a bunch of repeat info in another forum (I asked this somewhere else and only got one curt response) but you guys over here seem to be 100 percent more helpful than some of the other forums. I would love to be able to model and figure out some of this myself but a bunch of the freeware programs seem to use Excel and I only have Quattro Pro on my computer and can't seem to get the downloads to work. So I will have to rely on your guys' expertise..... if you will indulge me that is. I just don't want to make a mistake so I appreciate if someone could check my plan and help me out. Thanks in advance.
Okay I have most of the stuff lined up. Buttkicker amp,terminals from Madisound, driver gasket and port cover from PE, sono and end caps cut to size I am just waiting on the TC Sounds driver which is en route. And I just need to have someone double check my #'s before I complete the sonosub. I am using a TC Sounds 15 inch driver powered by a buttkicker amp. The tube is 24 inch by 48 inches tall which I think is about 300 L. I am not positive though about my volume calculations.
Question 1. I have looked at a bunch of different designs on this site and others and I am not sure exactly what length to cut my 6 inch port (it will be flared on both ends) I would like to get the tuning down to at least 15 hz. I know the typical range is between 25 to 33 inches but does a longer port lower the tuning or raise it? What length should mine be? Sorry I am a noob.
Question 2. lining the tube. I have seen people line it with insulation, poly-batting from Walmart, egg crate foam, accoustic foam, etc.... Would something like egg crate foam used for mattress pads work? I know I have seen them for about 10 bucks for a twin size.
Question 3. If I swap out the 15 inch driver for a different one down the road does that change the tuning of the sonotube? Or does it effectively remain the same? Let's say I switch from a 2000 to a 3000 or one of their 5400 lines? Or would I need to change the port length for the different driver?
Thanks in advance for all your help!!!
Chad.
Okay I have most of the stuff lined up. Buttkicker amp,terminals from Madisound, driver gasket and port cover from PE, sono and end caps cut to size I am just waiting on the TC Sounds driver which is en route. And I just need to have someone double check my #'s before I complete the sonosub. I am using a TC Sounds 15 inch driver powered by a buttkicker amp. The tube is 24 inch by 48 inches tall which I think is about 300 L. I am not positive though about my volume calculations.
Question 1. I have looked at a bunch of different designs on this site and others and I am not sure exactly what length to cut my 6 inch port (it will be flared on both ends) I would like to get the tuning down to at least 15 hz. I know the typical range is between 25 to 33 inches but does a longer port lower the tuning or raise it? What length should mine be? Sorry I am a noob.
Question 2. lining the tube. I have seen people line it with insulation, poly-batting from Walmart, egg crate foam, accoustic foam, etc.... Would something like egg crate foam used for mattress pads work? I know I have seen them for about 10 bucks for a twin size.
Question 3. If I swap out the 15 inch driver for a different one down the road does that change the tuning of the sonotube? Or does it effectively remain the same? Let's say I switch from a 2000 to a 3000 or one of their 5400 lines? Or would I need to change the port length for the different driver?
Thanks in advance for all your help!!!
Chad.