Home Theater Forum and Systems banner

sonotube build

1K views 2 replies 3 participants last post by  Mike P. 
#1 ·
chef tim here ready to make my cuts for my tube assembly.My sdx-15's arrive tomorrow along with my ep4000.I have all of my measurements except for the double speaker mounts using 3/4'' mdf and any extras for securing the driver as in glue or silicone adheasive needed?
 
#2 ·
Look forward to it Tim :T I'm not sure I understand your question though. Once you get your driver you will be able to measure any driver mounting holes required. As for gluing, if your using a double thickness front baffle to flush mount the driver, I would glue the two panels together as well as put in a few screws for good measure to increase the strength of the front baffle.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top