Tang Band W69-1042M project

**Avalon** · **09-17-09, 06:48 AM**

Quote:

Mike P. wrote:

The box can work. Green is with 2 drivers tuned to 40 hz. A single 3.75" port would need to be 5.75" long. Orange is with 1 driver in the box tuned to 34 hz. A single 3.75" port would need to be 9" long. The same power input and Hi-Pass filter applies as above.

Attachment 15855

So, even if I have 2 drivers in 1 box, I will need only 1 port, and not 2 right..kindly confirm. Thanks.

**Mike P.** · **09-17-09, 03:36 PM**

That is correct.

**Avalon** · **09-19-09, 04:13 AM**

Thanks Mike..Shall let you know how it works out, Am still waiting for the speakers to come in..lets hope it come in soon so I can start, as I cannot make the cutouts before that, do u think the cutout dimensions are available so I can cut out the cabinets and keep them ready..thanks.

**Mike P.** · **09-19-09, 11:44 AM**

For cutout information you can try the Tang Band website.

**Avalon** · **09-28-09, 07:57 AM**

Hi Mike,

Could not get the details from the website. there is Part # w69-1042J, but there is not cut out details mentioned either.

One more questions, what is the High pass filetr used for. What if the signal going to this subwoofer is only dedicated for the sub from my Yamaha DSP-800 processor.

Regards.

**Mike P.** · **09-28-09, 08:15 AM**

Wait until you get the subs to see what the cut out size will be.

The hi pass filter set at 30 hz will block the frequencies lower then 30 hz so the sub doesn't bottom out from over excursion.

**Avalon** · **09-28-09, 08:42 AM**

Fine. No problems. I shall wait for the subs..It has been nearly 9 weeks now, that's why I thought I'd start with the enclosures. Do you have any links of filters or website, where I can get this from. Thanks.

**Mike P.** · **09-28-09, 03:15 PM**

The Reckhorn B1 would be the cheapest.

http://www.creativesound.ca/details.php?model=B-1

Advertisement