- REW/BFD input level setup on a yamaha r-v661 ?
- first few graphs,...feedback please
- Sound card problems..
- sb live setup help
- REW crossover slope oddity
- On Minimal EQ, Target Levels, and a Hard-Knee House Curve (long)
- Now What?? after measurements
- Problem calibrating soundcard 24bit Live
- Need to calibrate RS SPL for rew?
- Help w/Output
- Frequency Response Graphs - Advice Needed
- Question on -3dbfs output level
- Need help with "Target Level"
- My equalization/room look ok?
- Please help!
- My first REW -- please chime in
- Vista and Edirol UA1-EX: Sound from mic (input) is being sent to output, bad results
- Parasitic mains?
- Non-noob noob questions about starting REW
- Room EQ \ Treatment Suggestions
- First graph. What do you guys make of this?!
- Macbook pro problems
- Using REW for sub distortion meaurements
- use of pink noise generator to check relative channel levels
- Sound Card Calibration Help - Newb
- No input mixers available
- Some tips for good measuring
- Attempts at using waterfall graphs with frequency response to set filters
- snafu
- Can Someone Help Me Interpret My Graph?
- Should Measure Be Mono?
- First Butchered Graph
- inconsistent results with the various sweep rates.
- soundcard calibration, what am I doing wrong.
- Moving from REW 3.x to 4.0 gold
- REW active filter question
- graph of my sub
- Setting up house curve??
- REW review and comparison to AP System 1
- use of multiple sweeps in measurement
- EMU 1820m Help? - Don't Think Calibration is Correct?
- Odd Impulse Response
- Fuzzmeasure Users: Can it do EQ emulation?
- sound card calibration problems
- REW and Edirol UA-1EX: Anyone get this to work on a mac?
- Can't get input to match output on calibration...
- Strange calibration result....
- My Graph
- Can't get rid of peak at 80Hz
- Different readings from different computers...
- Filtering with an sblive/audigy/audigy 2
- Can't get REW to import response
- Soundcard problems: Native Instruments Audio Kontrol 1
- MP3+ Setup?
- E-MU 1616M soundcard calibration help needed.
- Is this response curve OK??
- computer noise
- help me interpret this graph
- newby questions
- Built a sonosub and have a question?
- compatible sound card enquiry
- Just curious how this compares. newb alert!
- Please help REW with FBQ2496
- sub hums if I turn on SPL meter
- Max cable length with REW?
- can REW measure sub delay?
- Please Help Me
- no gain on sub amp
- BFD filters nothing like predicted response.
- Room mode measurements
- Question about multiple subs in REW
- Sure would like to add some boost .....
- Now this isn't right...
- Will this work?
- What is Q Factor?