- REW: Export Filters Response as wav
- USB to MIDI interface...
- Bergo´s Graphs
- Cowboys in my IB?
- sweep or sine wave ?
- Filters only above 100hz
- soundcard calibration check.
- First Round w/ REW -- Mixed Results
- accuracy of REW for full range measurements?
- Inconsistent Results
- Error Message on Windows Vista
- sub localizing
- House Curve Options
- Sub volume on A/V processor
- Using REW filter info
- Help! REW RS SPL correction seems inverted?
- Can REW be used to diagnose a speaker?
- Hello Folks
- My first measure
- About EQ Wizard???
- Room Eq Wizard
- Error in Help ?
- Target response / House curve
- FINALLY got the USB soundcard, now I'm ready to tackle REW!
- Did I get my sub equalized right?
- Just getting started
- New to the Shack, my first BFD graph :)
- Setup: Have I done it correctly?
- The dreaded "little endian not supported" error
- Response graph
- New to REW, few questions to get me started.
- High Low frequencies
- Waterfall interpretation
- 100+ dB at 10 Hz?
- using the DEQ 2496 with rew, warning, mainly graphics.
- EQ'ing my new IB
- Anybody in Eastern PA would like to help in with REW
- REW with M-Audio Fast Track Pro
- Baseline graph 15-200Hz sweep - do I need bass traps?
- Are the following sound cards suitable for the REW?
- New sub, some same old questions
- REW crashing on Intel Mac - why?
- Order of Calibration?
- REW and DRC
- New Sub: Monolith Response, any thoughts?
- SB Audigy 2 Platinum and REW
- Set up problems, looking for help pls
- Hsu VTF-3 HO REQ results....suggestions?
- phase shifts
- First post with pic. Hello!!!
- help with creative mp3 soundblaster setup
- SB MP3+ or M-Audio for laptop
- Data (correction values) beyond 100Hz?
- REW helped me relocate my sub :-)
- Wierd results when measuring soundcard response, need new S/Card??
- Getting my feet wet with REW and the BFD
- good enough w/o BFD?
- Filters wont load to DSP 1124
- M-audio mobiel pre usb
- Preamp for external mic
- M Audio MobilePre Issues
- Using REW with QSC
- Creative MP3+ discontinued???
- Room EQ Wizard, true RTA, ETF - any need for all?
- Setting BFD problem
- Doing the REW and BFD thing - general discussion and questions along the way
- Tonal EQ calibration (there's more than subwoofers in your system!)
- REW for pro sound (interesting but long!)
- Channel level calibration RS or REW??
- Boosting is boosting however you do it?
- Cutoff on Sub and Front
- REW as an RTA?
- midi interface question...
- Comment on Klipsch Forums regarding Room EQ Wizard
- My graphs