PDA

View Full Version : REW Forum


Pages : 1 2 3 [4] 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25



  1. Is the film industry's X curve suitable for home theater?
  2. Soundcard problem
  3. Comments on my first measurements?
  4. Clipping Detected - Why?
  5. M-audio mobilePRE on Vista?
  6. REW and Digidesign Interfaces
  7. Using RTA to position subs/mains
  8. when new version of REW is coming out?
  9. House Curve Question
  10. Another "Does my Soundcard Cal graph looks okay?" Thread
  11. Phase issue, or what?
  12. Got the basics, now need to get to grips with the technical stuff!
  13. Can't calibrate soundcard
  14. REW working first graph post Kappa 12VQ
  15. Soundcard Calibration L/R Difference
  16. Using REW to find best sub location
  17. no sound on linux
  18. Question about main and sub intergration
  19. New to REW calibration problems
  20. ECM8000 Connection Issue (ground loop?)
  21. To Clear Calibration Process Set Up Concepts
  22. New feature for REW?
  23. Looks like REW can help me too
  24. Just purchased ECM8000 and MP13
  25. Audigy 2 NX Soundcard ok for REW?
  26. REW for me or not?
  27. Delayed start of measurement
  28. New first REW run with everything calibrated correctly!?
  29. SPL Calibration question
  30. First attempt at REW after several amatuer adjustments
  31. Can't calibrate my soundcard
  32. My First Measurement
  33. Another new REW user: first graphs
  34. Cannot calibrate creative x-fi soundcard
  35. REW and 1820m
  36. First shot at REW w/graphs
  37. Attempted to dampen the back wall
  38. Adding a second sub: not the same as primary...
  39. First Attempt to Measure Dual SVS PB13 Ultras
  40. First room measurement - graphs inside
  41. Sub position/phase graphs
  42. Is any of the EQ Simulators in REW comparable to Inguz?
  43. C Weighting Setup Questions
  44. Calibration help?
  45. Calibration 20db off?
  46. First graph with DIY sub
  47. Help, No Input mixers available - error
  48. 1st attempt charts : looking for advise
  49. Mains have wild response compared to subs, is this normal?
  50. Where to find Tripod
  51. Going back to old laptop and SB USB Ext Card
  52. Exporting IR as pcm file?
  53. .cal file for Audessey mic
  54. Anyone measure in car?
  55. RS meter woes II
  56. Tascam 144 calibration
  57. Starting Over. Sub EQ, Speaker EQ, room treatment
  58. Can REW create IR wav files for convolution?
  59. REW is a time saver! - First Graph
  60. REW: Stuck making first measurement
  61. REW graphed without a mic?!?
  62. DIGITAL RS meter woes
  63. REW distortion measurements
  64. How's my house curve?
  65. "Assign filters" is grayed out, why?
  66. my first graph.
  67. Help using MOTU Ultralite with REW
  68. Advice on HT audio setup
  69. Hmm, that doesnt sound like a sine wave
  70. Cable question?
  71. How do I create and save a Hard-Knee curve?
  72. SB X-Fi - which "mode" to use when calibrating ?
  73. sound blaster X-FI calabration Help
  74. Calibration files - not radioshack
  75. Signal Chain Question