Home Theater Forum and Systems banner

Umik-1 setup with REW

Tags
setup umik1
2K views 3 replies 2 participants last post by  JohnM 
#1 ·
In the wizard for setting up the Umik-1 with REW, there is the following step:"Now open the REW SPL Meter. Click on the red button in the lower right corner to turn it on, and adjust your system volume until the meter reads about 75 dB." I have done that and everything is OK! But when I go to the "Measure" section and click "Check levels" then it indicates "low level"? Something wrong?
/Ake
 
#2 ·
Depends what you are measuring and how you have set up the measurement sweep. If you are measuring a sub but the end of the sweep is set to 20 kHz (say) the check levels signal will be a speaker cal signal, which is outside the frequency range of a sub and so won't generate much level. Difficult to speculate beyond that without some screenshots or information about how you have set things up.
 
#3 ·
Thanks John,
I am measuring speakers not a sub. As i said i followed the wizard and i can make the measure, i get the result and so on. But when I click "Check levels" then it indicates "low level". Could it be that the Umik-1 is so sensitive and the initial 75dB is enough ?
/Ake
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top