| |
| ![]() | ![]() | |||||||
| REW Forum Question in regards to hook upDiscuss Question in regards to hook up in the Subwoofer Equalization | Calibration forum; Question in regards to hook up In the cable hook up thread this is stated :
"A microphone input on the soundcard is not suitable (many ... |
|
| | Thread Tools |
| | #1 (Link) | |||
| Question in regards to hook up In the cable hook up thread this is stated : "A microphone input on the soundcard is not suitable (many laptops only have mic-in)." I am trying to keep cost down and not purchase an external soundcard so help me answer........... Why is this? please help me understand......thanks | |||
|
| | |
| | |
| | #2 (Link) | ||||
| Re: Question in regards to hook up Quote:
SPL meters (such as the Radio Shack meter) output a line-level voltage signal. The microphone input jack offers high gain since actual microphone signals are quite low in relation to a line level signal. This extra gain at the mic inputs front end usually results in increased noise. Mic inputs usually enjoy a very limited bandwidth that is designed to comply with a narrow voice frequency range that a cheap microphone would supply. The port often supplies a 5 volts bias signal also. You require a line-in to use REW. brucek | ||||
|
![]() |
| « » |
| « |
| |
| Bookmarks |
| Thread Tools | |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hook up BFD/EP2500.. | Rodny Alvarez | System Setup and Connection | 18 | 02-04-08 02:08 PM |
| Multiply System Hook-up | Pauljs | BFD Forum | 9 | 10-10-07 01:51 PM |
| REW hook up and set up help | wackii | REW Forum | 18 | 10-03-06 11:01 AM |
| BFD and REW question about hook up and calibration | apilon | REW Forum | 8 | 08-08-06 11:55 AM |