Epik Tower First Graph!!!

This is my first attempt at getting REW to work. Just got my Tower about 2 hours ago, and so far it's SCARY! Watched the scene in Live Free of Die Hard where the car flips over McCain and the kid in the tunnel and it was unreal. My eyeballs we're shaking!

Anyways this is my first graph. I am pretty sure it is in the correct format. I left it unsmoothed. I had to adjust the phase to 180 because at 0 I had some crazy 20db dips at 75 and 85 HZ. This is mains + sub. The sub is in the front left corner. I set it on about 5 inches of foam to help with vibrations going through the floor.

I am going to try to learn about house curves, and I don't have a BFD yet.

Any thoughts on the FR?

Thanks!

Matt

[Wayne A. Pflughaupt]

Nice response, Matt! Should take no more than a couple of filters to clean it up.

Regards,
Wayne

[brucek]

Any thoughts on the FR?

Yep, you don't have to learn about house curves, since you already have one.

Take a few db off at ~25Hz and ~45Hz and you're done. In fact, I might move it around a small amount and see if I can lower the small humps a bit and you could forget about a BFD.

brucek