| ||||||||||||||||||||||
| ![]() | ![]() | |||||||
| REW Forum Dual 3.3 Turbos with Dual MDM-12s graphDiscuss Dual 3.3 Turbos with Dual MDM-12s graph in the Equalization | Calibration forum; Dual 3.3 Turbos with Dual MDM-12s graph Let me know what you think about my graph.... |
|
|
Views: 356 - Replies: 5
| Thread Tools |
| | |
| | |
| | #2 | ||||
| Re: Dual 3.3 Turbos with Dual MDM-12s graph Looks fine. A bit excessive down low. I suspect the subs are corner loaded. If so, you might move them from the corner somewhat to tame the ramping up at 15Hz.. brucek | ||||
|
| | #3 | |||||
| Re: Dual 3.3 Turbos with Dual MDM-12s graph Quote:
I just ordered a BEHRINGER DSP1124P will this help me out? | |||||
|
| | #4 | ||||
| Re: Dual 3.3 Turbos with Dual MDM-12s graph Well, the Behringers lowest filter capability is 20Hz. It extends lower than that of course, so should certainly help out. I suspect you have your sub(s) in a corner? brucek | ||||
|
| | #5 | ||||
| Re: Dual 3.3 Turbos with Dual MDM-12s graph Yes I do but, this is the only option I have is to put them in a corner. It extends lower then 20hz but you can not apply any filters lower than 20hz? Looking at my graph where do you think I need to apply the filters to? Last edited by Bori; 11-10-08 at 09:48 PM.. | ||||
|
| | #6 | |||||
| Re: Dual 3.3 Turbos with Dual MDM-12s graph Quote:
You might consider pulling them out of the corner just a couple of inches too. I had 2 MBMs and 33T and was happiest with just the 33T in front corner. Ended up selling them all and going to a SVS PB13 Ultra. The SVS has 1 EQ filter and now have that working for me and have removed the BFD. ![]() All is good now, still missed some of the mid bass punch but a pair of Vintage Polk Monitor 12s took care of that. ![]() I have come to conclusion that MBMs did not work for me and my mains were keeping me from mid bass punch. With MBMs requiring my 33T XO be set at 45-50HZ I was missing some of the best bass from the 33T. | |||||
|