first time user and not a wizard....

[brucek]

I have attached the same in a LOG

OK, those are all quite bad.

Let's start from scratch. I'm sure we can figure out the problem.

Can you post a pic of your settings page.....

brucek

[jtwrace]

brucek wrote:

OK, those are all quite bad.

Let's start from scratch. I'm sure we can figure out the problem.

Can you post a pic of your settings page.....

brucek

the settings page...

[brucek]

I'd like to see if the card is actually being recognized by REW.

Can you pull down the Output and Input Device Lists and actually select your card, and then select the line-out speaker and the line-in?

Here's an example of my Envy24 card with all the other correct settings. You can see once I select the cards that nothing is grayed out...



brucek

[jtwrace]

yes, I can see all of that...how are you posting that page in the post?

[brucek]

yes, I can see all of that...

Can you show me the Settings page with all that set ?......

how are you posting that page

Place the mouse over the page of interest and select ALT plus PrtScr keyboard keys.
That copies the screen to the clipboard.
Start Windows Paint and Paste the clipboard to the app.
Save as a jpg of the correct size and post.

brucek

[jtwrace]

try this

[brucek]

Select Line-in and not Mic-in........

Also select 48Khz sample rate........

brucek

[jtwrace]

brucek wrote:

Select Line-in and not Mic-in........

Also select 48Khz sample rate........

brucek

there is not an option for line in...

[brucek]

I suppose it must auto detect then.....

OK, all that seems fine then.

Let's carry on.

Tell me about the connection from line-out to line in that you're using to do the soundcard cal routine.

Do you have 1/8" stereo plugs that splits the right and left channels out, and then you connect a single cable from the line-out right to the line-in right?

brucek

[jtwrace]

brucek wrote:

I suppose it must auto detect then.....

OK, all that seems fine then.

Let's carry on.

Tell me about the connection from line-out to line in that you're using to do the soundcard cal routine.

Do you have 1/8" stereo plugs that splits the right and left channels out, and then you connect a single cable from the line-out right to the line-in right?

brucek

I'm using a Y 1/8" plug on one end and RCA (L&R) on the other. but I'm only using the R ch wire. It is a loop on the sound card.