Filters only above 100hz

[sammythebu11]

Hi,
I am trying to Equalize my IB sub and I am doing everything (I think) according to the guide but when I get to the point of "Assign Filters" the software only generates filters above 100hz.
I am using a mac and I can:
Set the measurement level successfully, I can calibrate successfully, I set the target level to 73.7.
When I "Find Peaks" sometimes I get a message saying that the peak is at 30 some DB and it is too low, sometimes I get through without any problems. if it is successfull and I click on Apply Filters, then the software applies between 6-7 filters ALL of them over 100hz and under 200hz.
Can someone please tell me what I am doing wrong?

Thanks,

The Bu11

[brucek]

You will have to adjust your target to give REW a better set of conditions to suggest its filters. If a peak is too wide or high, no filter will be suggested.

In this case either change your target or simply apply your own manual filters. Since REW shows you the results, it's fairly easy to do on your own..

brucek