"No peaks to correct" message from REW

[Mitch G]

Just for snicks, I thought I would re-run REW (4.0) on my system which I had already equalized a while back.
After making the measurement - which turned out exactly the same as the first time - I clicked on the "Assign Filters" option under Filter Tasks and was told that there are "No peaks to correct."
In REW 3.x, I was able to get a set of filters created.

So, I'm wondering if there are some thresholds I can play with to force REW to come up with some filters.

Thanks,


Mitch

[brucek]

I'm wondering if there are some thresholds I can play with to force REW to come up with some filters.

After your measurement is done, you simply adjust the Target Level thumbwheel up or down to get more or less response information considered by the Find Peaks function....

brucek

[cyberbri]

Yes, the "find peaks" will find peaks above whatever your target level is set to.