Hi All,
I went through the basic REW setup and calibration and am able to run basic measurements. I am unable to find any option that allows sending the signal to LFE channel only. The "Make a measurement" dialog only asks for start and end frquencies but doesn't see to allow restricting the output to LFE channel.
I need to measure LFE channel only, mains only, and LFE + mains. I can meaure the second and the third by physically turning the sub on and off but I am not sure how to measure the sub only.
Your help is highly appreciated!
I went through the basic REW setup and calibration and am able to run basic measurements. I am unable to find any option that allows sending the signal to LFE channel only. The "Make a measurement" dialog only asks for start and end frquencies but doesn't see to allow restricting the output to LFE channel.
I need to measure LFE channel only, mains only, and LFE + mains. I can meaure the second and the third by physically turning the sub on and off but I am not sure how to measure the sub only.
Your help is highly appreciated!