Home Theater Forum and Systems banner

Mic

Tags
mic
1K views 4 replies 3 participants last post by  fibreKid 
G
#1 ·
So, I've hooked the mic up and tested it to make sure it works, but I still don't get a signal when I try to calibrate it.

That's all. I'm sure it's something small..?
 
G
#4 ·
Oh...I meant calibrate the SPL. You know, it plays pink noise and you put in the level showing on your SPL meter.


Actually, I can't afford a real mic right now, so I was trying to use the mic that came with my Pioneer Elite for the acoustic calibration the receiver does.

Basically, REW doesn't show any evidence of input while I tested it with the computer mic test and input was verified.

I was hoping to just get a relative idea of measurements. :thud:
 
#5 ·
I don't know for sure but that mic that came with your AVR might require a pre amp if it's used alone. That's the long answer, the short answer it won't work. Yep it's time to go out an buy more toys. Tis the season :devil:

Good luck
-john
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top